Why would an Engineer consider combining FEEDBACK and
FEEDFORWARD control in some applications?
Answer Posted / bhag singh
control valve
Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
Manipulation of dead wt. tester double piston type.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is the use of control cable?
What is instrumentation control?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
what is the difference between -24 : +24 & 0:24 and where it use?
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
Explain the use of hair spring in the pressure gauge.
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
what is the criteria to decide conductor size of a cable ?
How ejector(or)evactor air pump is working in thermal power plant?
how do calibrate the valves.. with clear manual
field bus transmitter calibration procedure tell me