we convert 66kv to 33 kv to 11kv to 440v. why can't we
directly convert 33kv to 440 ?
- 9 Answers
- 37617 Views
- EMC, Jakson, L&T, I also Faced
- E-Mail Answers
Answer Posted / siva
converting very high volyage to very low voltage is
impossible because while making the system to convert the
windings in the machine will damage, and the making of 33kv
to 440v the cost very high, and complex
| Is This Answer Correct ? | 30 Yes | 14 No |
Post New Answer View All Answers
Z transform is use when system is not a) converges b) diverges
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
plz tel me syllabus and exam date 4 jr executive engg (electrical)
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
Explain (in simple ) - root mean square. whats its role in electrical fundamandal.where its used
How to convert 2 phase to 3 phase electricpower in induction moter?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
Why arc quenching is used in Diode ?
HI SIR, AM PREPARING FOR RRB FOR SECTION ENGINEER POST. PLZ SEND ME THE PREVIOUS QUESTION PAPERS AND HELP ME. I HAVE NO ENOUGH TIME MY EXAM DATE IS 22ND JUNE.... MY EMAIL ID IS nalla.amarnath@gmail.com
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
