Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any software to prepare the Estimate of building.Plz
tell me.......
- 10 Answers
- 13810 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / anand
estimator 2
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How many litres of water used for curing of 1000sqft of slav
how much percent are used 20mm,10mm?
How do you maintain water pressure?
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
How much cum. Brick work can do by 1 madon
why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..
What are the causes of building collapse?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
Journal entry Gross salary 10000 Tax 1000 Employee contribution 2000 Employer contribution 2000
what is total volume of ingredients used in concrete accordingly
Can a wave happen in the middle of the ocean like in the movie poseidon 2006?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
We are into industrial flooring (epoxy flooring) business. We buy material from manufacturers.We supply and laying the to companies. In our billing what tax/ taxes to be claimed from companies? Are we applicable for only WCT or any else?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
How to design staircase.plz tell me formula for the design the staircase.
