Answer Posted / zuber ahmed

Granite is greater in strength and resistant to stains,acids,scratches,heat,etc...whereas marble have lesser strength and sensitive to acidic products in comparison...

we have a crushing plant and our product is experiencing flakiness and elongation over limit for granite. what is the solution to this problem? how can it be avoided and what to do differently? It is not ok for batching plants

2176

---

show answer/calculate mix 1:2:4 ratio -cement-sand -metal-water

2079

---

what is the mode of method of face bar measurement

2597

---

how to calculate the material from ratio of work PCC, RRM,POINTING, RCC

2636

---

how to determine H- zone in a column? where it will occur?

2221

---

I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.

2086

---

what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)

2006

---

how i get all type of short type question answer about civil engg

1701

---

qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor

2254

---

What are the delays in construction projects due to approvals from owners? How can we analyze them in different prospective? Whats their affects and effects on presently going work?

2118

---

what is polity

2117

---

how to calculate the rebar depth if forgot the foundation reinforcement (main steel)? is that any calculation or formula we have data sheet of supplier what depth what is the pull out capacity is mensioned in data sheet. if any IS code than its help full to me.

2644

---

How many cum of 9.5mm stone in 1 ton ?

2543

---

does a b.tech civil engineer fresher supposed to know how to design rcc structure?

3473

---

How can calculate the requirement of steel bars of rcc slab for 1100 sq ft?

2048

---