Interested to Buy Any Domain ? << Click Here >> for more details...
In a transformer, the hysteresis and eddy current losses
depend upon
1.load current
2.maximum flux density in core
3.type of lamination
4.supply frequency
The correct statements are
(a) 1 and 3 (b) 2 and 3
(c) 1 and 4 (d) 2 and 4
- 9 Answers
- 13354 Views
- I also Faced
- E-Mail Answers
Answer Posted / sridhar
2 & 4
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
how to calculation increase power factor for single phase
Electronic circuit
the problem faced on star or delta winding connection??
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
how we findout a ignater is faulty or not?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
what are the condition that makes hooter blow?
Hoe do calculate the Cable size for Amps rating ?
what could be the RMS value and average value of a 4 phase sine wave?
what is the best transformer oil breakdown voltage?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
In parallel operation time both NGR’s close or not close if both close what will happen
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
