Interested to Buy Any Domain ? << Click Here >> for more details...
Why the substation measure in KV but not in the power ratings of transformer.
- 4 Answers
- 6705 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil bhuarya
above answer is correct if we talk about transformer, but as question is why s/s in kv....?? transmission capacity of incoming feeder is named as 400Kv, 220KV 132KV and so on...
for ex. in 220KV/132KV/33KV s/s there will be at least one /two 220Kv line and 132KV outgoing feeders that may be depend on the requirement..
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
WHAT IS counter flux IN CT?
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
What is tan delta & PPM in transformer? and whats its IS value?
Why have to use copper cable for local isolator to motor ?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
Single line diagram for dbb (double bus bar)system.
What is mean by hot and cold loop testing? What is the difference between them?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
how to calculate the change over time for star delta starter for different KW motor?
How to calculate multiplication factor in kva example 500kva ans pls ?
Can we convert off line transformer to on line transformer
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
Why is a synchronous motor always star connected??
what is the minimum voltage require to injure our body?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
