Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
1.A good conductor 2.has desired hardness 3 can be easily
Reshaped 4.cheap 5. easily available 5. does not corrode 6.
cleaning is easy 7.weather resistant 8 not inflammable etc
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
a governer in an Ic engine controls the
PLZ EXPLIN ABOUT CLASS PS CLASS CT .WHY THEY R DESINED AND FOR WHAT PURPOSE?WHY OTHER CT CANT BE USED AS PS CLASS CT? EXPLAIN IN SIMPLE LAUNGAGE IF POSSIBLE PLZ GIVE CIRCIT DIAGRAM?EMAIL-RAJ_SINGH_0376@SIFY.COM
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
clarify types of motor operated valves and advantages
draw the block diagram of fire alarm?
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
star delta starter contorl circuit... drawing..
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
what is the difference between torque induced and torque load?compare them with respect to dc motor?
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai
working of diesel generator ?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
