Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bhavesh chauhan
First of all let us know what is Tan Delta......?
Tan Delta Testing of a transformer or a CT or a PT determines integrity of insulation of the equipment which determines the remaining life of the equipment. Tan Delta is also called as loss angle or Dissipation Factor Testing.
In a perfect capacitor the curve of voltage vs current are phase shifted by 90..in case if any impurities are present the phase shift wont be 90 degree any more which means it will be less than 90. Thus by measuring new angle developed less than 90 we can calculate the loss angle or the level of insulation.
Measuring of Tan Delta is very simple..We have a Tan Delta Kit which has two terminals coming out of it. Applying the two terminals on top and bottom of the equipment and injecting the current through kit we can get the values of the test..
Tan delta Point is nothing but a point covered by a nut bolt on the bottom side of Bushing of transformer and CT..............
| Is This Answer Correct ? | 34 Yes | 14 No |
Post New Answer View All Answers
What is the permissable nutral current of three phase system as per IS standards?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
who can measure the size of power cable?
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
what is the circutor?why we use it ?
what is the saturation point of crgo lamination.
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
Explain about Leakage Test.
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
