when we are using HART COMMUNICATOR why we are using 250 ohm
resistance while using HART COMMUNICATOR.
Answer Posted / g.ramesh
because of the load impedence it should need the 250
resistor at time only we are able to get the frequency
of 1200hz to 2200 hz
Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
please tel me the calibration of pneumatic controler.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
How to Calibrate Flow Switch in field
How we calculate orifice plat size???
what is scale factor of proximitor & unit of the vibration.
how to convert cubic metre per hour to newton cubic metre per hour
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
what is the reason while warning lamp is on while the engine is cranking?
What is the difference between ff transmitter and non ff transmitter
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
Can anyone send most commonly asked interview question in Oil & Gas industry
Why are the uses 24vdc in industries