Interested to Buy Any Domain ? << Click Here >> for more details...
can we use the step down transformer to step up transformer
- 6 Answers
- 8930 Views
- I also Faced
- E-Mail Answers
Answer Posted / lokeshraj
Yes we can use this in both step up and step down. But the
transformation ratio is not same in both case. It would be
slightly different.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
during installation time of transformer and alternator which points we have to observed?
how much allowable resistance that can be difference in motor all coils?
How is the speed of a DC shunt motor related to the armature current?
In parallel operation time both NGR’s close or not close if both close what will happen
How earthing/grounding done in aeroplanes and ships.
how we find transformer capacity by ohm
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
how will we calculate the copper wire load..
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
How can we choose the rating of submersible motors
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
What is maximum power transfer theorem?
how to discharge 3 phase power factor correction capacitors
