Interested to Buy Any Domain ? << Click Here >> for more details...
can we use the step down transformer to step up transformer
- 6 Answers
- 8638 Views
- I also Faced
- E-Mail Answers
Answer Posted / j.karthik
ya,its possible.. for ex: using a 11kv/415volt step down
transformer, in this primary voltage is 11kV and the
secondary voltage is 415volt(step down transformer)... now
we giving the input voltage to the 415volt side of the
transformer now the primary voltage is 415volt and secondary
voltage is 11kV(step up transformer).....
The step up and step down transformer is deponds upon
the input voltage is feeding side of the transformer(Primary
or secondary side)
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
why and how voltage sharing in transformer, during magnetic balance test ?
Explain bypass capacitor?
main difference between ac and dc?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
Please send 110 kv sb station full single line drawing(sld)
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
IN 1000kva transformer where the oil and winding temperature sensors is connected
What is the function of retrip in busbar?
Testing procedure of DG alternator stability test
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
why zero sequence impedance measurement is not applicable for single phase GT
