Interested to Buy Any Domain ? << Click Here >> for more details...
What will hapen if we connect more capacitors than required
for powerfactor control? Exactly what will be the effect on
power system?
- 2 Answers
- 5233 Views
- Mandovi Pellets, I also Faced
- E-Mail Answers
Answer Posted / ashfaq
it will definitely improve power factor,but the problem is
if we installed more capacitor than required then receiving
voltage will be greater than sending voltage,farrantic
effect will happen
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Mention the disadvantages of low power factor?
how to calculate units consumption for a 12 hp motor /hr.
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
Pls mail me utility & Dg related question with answer
what is the control circuit for operating the clean room air shower
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
and gate circuit diagram,amplifier circuit diagram
how to control the speed to switched reluctance motor
why we use circuit breakers for switching instead of normal switching device?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
what is the ATS .And how it works.
