What is Ohms law?
- 28 Answers
- 28491 Views
- College School Exams Tests, KPTCL, L&T, I also Faced
- E-Mail Answers
Answer Posted / satya
If any electrical ckt,The current is directly proportional
to the applied voltage And indirectly proportional to the
Resistance of the ckt.And remaining temperature is same
V = I x R or R = V/I or I = V/R
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
how to calculate the change over time for star delta starter for different KW motor?
What will be the effect if I use inverter as UPS mood?
Which type of questions well asked. ?
how many stairs have you climbed while you were coming
What is stepper motor. What is its uses?
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
is the value of inductance depends upon the value of thitha in doubly excited machine??
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
how current is reverse from its normal direction during the fault?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
What is the difference between a 3 winding and 2 winding Potential Transformer
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
