how to check a three phase induction motor by multimeter &
megger?
- 2 Answers
- 18697 Views
- I also Faced
- E-Mail Answers
Answer Posted / gajanand solanki
Check the resistance of the three winding it should be balance.
Then check for any grounding all the winding should show
resistance in mega ohm.
rotate the rotor it should freely rotate this will confirm
no bearing damage.
| Is This Answer Correct ? | 33 Yes | 1 No |
Post New Answer View All Answers
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
Under wat condition statcom operates as an inductor for the transmission line?
what is the best method of grounding in 30 MW generator?
What is cut-off rate?
wat system call?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
please send previous exams question papers
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
Name two low frequency oscillators?
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
what is the difference b/w ground & virtual ground?
what is sevice settings for mccb?How can be it setted?
