Interested to Buy Any Domain ? << Click Here >> for more details...
why can not run two different phase circuit in to the same conduite
- 1 Answers
- 4187 Views
- I also Faced
- E-Mail Answers
Answer Posted / benedict
In PHASE SEGREGATED Distribution Boards Outgoings are three compartments.so phase are difference and Neutral and earth are looping.In outgoings are going to loads all are separated.suppose neutral and earth wires are short the mcb was tripped.so checking is the main problem.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
What is meant by stator?
single phase power supply give to separate one steel coup with water, what reaction create
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
Define super node?
what is ramping rate of generator
What are the uses of stepper motor?
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
33kv substation lay out details & line to line & line to earth measurements
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
Is a d.c.compound motor is use as a booster? how?
