Interested to Buy Any Domain ? << Click Here >> for more details...
why 3 phase motors are preferable over single phase motors ?
- 4 Answers
- 6597 Views
- I also Faced
- E-Mail Answers
Answer Posted / dileep
because if u take a same capacity rating of both 1 phase
and 3 phase ,the size of 3 -phase motor is small compared
to 1-phase.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How to calculate Number of Earthing Pits....???
Motor,transformers,capacitor tubelight etc....
At what speed 1 HP motor can run an electric car of weighing 400 kg?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
what is current check gurd relay?
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
what is self capacitance of inductor
When are the directional relays used?
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
Define end float in a motor?
what is meant by impedance & transient protection?
