Interested to Buy Any Domain ? << Click Here >> for more details...
i install a DP transmitter of Faugi on drum level of boiler
but i face a problem in it when i engergize the transmitter
the meter shows 0 or 100% no variation in it.the distance
of two points is 19.5 inches, i am in trouble please
suggest me what can i do it's very urgent Please reply me
as soon as possible
Best regards
ikraam haider
- 5 Answers
- 8014 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.arunraja
Hello Dear first check the Calibration Range of Transmitter,
Range should be -xxx(495) to 0 mmwc. for 0 mmwc 20 mA will
be come.when you fill the water in condensate pot 4mA wii
be come because it's closed vessels
Regards
S.Arun Raja
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is diffrance between FF & SMART, explain with difination
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
What is frequency factor in massflow meter? When using frequency output?
give some question relative instrument fitter?
how u choose thermowell lenght n pnumatic C/v size?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How to Calibrate Ultrasonic flow Transmitter in Field
what is the protection system in solar turbine compressor
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
