Interested to Buy Any Domain ? << Click Here >> for more details...
How can we calculate the resistance of earthing & how can we
control it?
- 2 Answers
- 5524 Views
- I also Faced
- E-Mail Answers
Answer Posted / meenakshi
i vud lyk to enhance mr.subbiah's answer...
for large power stations- 0.5 ohm
major power station - 1 ohm
small substation - 2 ohm
other cases - 8 ohm
controlling here means the measures 2 b taken to reduce the
earth resis value
- use no of earth electrodes in parrlel connection
- v can replace the existing electrode by a larger dia
electrode
- depth of pit can b icreased in order to get more moisture
n water content in the soil
-n the important method as mentioned by subbiah
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
Why is tan-delta test and capacitor measurement done on alternator?
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
What is the meaning of C1, C61, C91 cable
how to protect motor in dol starter having capacity of 30 hp.40 hp?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
what's producer of XLPE cable laying in undergroung
what can be the causes of capacitor start motor having a higher current that its actual
what is the meaning of neutral displacement ???
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
what is the function of impulse relay
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
what about SAP/MRP regarding manufacturing of electric motors and all drives?
what is the difference between b c d curves on mcb
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
