Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mriganka das
Class 0f CT : 5P10.....
It state that if there 10 times current of plug setting
flows through the primary, there would be +/- 5 % error may
take place in the secondary side of the CT.
So 5 is the tolarence or accuracy class & 10 is the
accuracy class limit factor.it is denoted by the symbol
Eeta.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
what is the working process of over & under voltage relay.
what is servo motor and how it works?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
What is the approximate value of stacking factor?
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
State magnitude criterion.
What is meant by reactance voltage?
While testing a ZCT what parameters have to check or measure?
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
What is lighting kitts.
What are the differences between single phase and three phase?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
