Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to joint the H.T and L.T Cables?
- 23 Answers
- 64374 Views
- KESC, MGVCL, Nokia, Oil Country Tubular, Power Control, SAGT, Siemens, Simco, Vivek Engineers, I also Faced
- E-Mail Answers
Answer Posted / praveen
hi friends
ht and lt joints are not so easy
it need concentration and special care
first we should remove the area which was damaged
remove the sleeve and insulated material(ht cable)
use feruls and then crimp them with crimping tool
then use mastic tape to cover the feruls
next place the heat sink sleeves and heat them with
electric hot blower(hot air gun)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
what is the transformer rush current?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
describe the Operation of induction generators from bus bars
how does grading rings & spacers in transmission line works? Working Principle?
How PSV sizing being done
What is the difference between rated and per unit in transformer?
WHat is the general checks required for Dry type transformers
can we find the inductance of a induction motor?
How to check the LM324 Ic
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
When can we take Neutral as common neutral link?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
WHAT IS MEANT BY DERATING OF THYRISTOR?
