Interested to Buy Any Domain ? << Click Here >> for more details...
what difference between tapping -15% to +5 % and -5% to
+15% tap. & how can define HV turns on maximun & minimum
tap of power transformer.
- 2 Answers
- 4949 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
That is correct.As the tapping is done on primary side, with
+5% tap you are decreasing secondary voltage by 5% or you
use that tap when the primary voltage increases by 5% to
maintain the secondary voltage steady.Then N1/N2 = 105/100
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
What is the working mechanism of OLTC in Power Transformers????
how to calculate kvar in Akiva
how do we calculate length of starting time and repeated starting of a direct online starter?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
How REF protects transformer alone? explain with diagram.
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
what is interfacing in computer studies?
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
size of condotory fron voltage level
whate is the meaning of balance/unbalance,in stabilizers type
Difference between transition and diffusion capacitance
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
