Interested to Buy Any Domain ? << Click Here >> for more details...
how many types of hydraulic coefficints and their values
- 2 Answers
- 6093 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj
Cd=coefficient of discharge
Cc=Coefficient of contraction
Cv=coefficient of variation
Cd=Cc*Cv
Cd can be between 0.6 to 0.8
In addition to this, there is another coeff. named as
coefficient of resistance, Cr. It can be defined as the
ratio of the loss of kinetic energy as the liquid flows
through the orifice and the actual kinetic energy possessed
by the flowing fluid.
Cr=((1/Cv^2)-1)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.
GIVE US DETAIL OF YOUR PRESENT EMPLOYMENT STATUS?
in levelling operation the first site on any change point is back site the second site on any change point is fore site the line commenses with fore sight & closes with backsight the line comensses with back sight & closes with fore sigh
estimate quanitity of bricks(19x9x9cm without mortar), cement & sand in 10feet X 10feet wall ?
How do you convert wind speed into force?
what will happen if one could not properly follow the spacing of slab reinforcement bar?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
What is the average density of soil?
In tower foundation, on the time of 3 mtr pit RCC casting if water and mud is their surface of PCC then what will be do?
02. a. The diagonal of a 9 cube…………… 1 b. Surface area of 9 cube…………… 1 c. Volume of 1-3 cube …………… 1 d. Compressive area of 6 cube …………… 1 e. Top & Bottom face of a Cylinder/Cube is to be proper leveled to deliver the…………………………..…… properly.
What is demising walls?
Critical Path Method is...
Define What is rigging?
Why are steel plates inserted inside bearings in elastomeric bearings?
