Interested to Buy Any Domain ? << Click Here >> for more details...
in the thermal power plant, why we use the condenser (for
cooling the steam) when we have to heat the steam again.
i mean why we are cooling the steam,
- 6 Answers
- 10666 Views
- I also Faced
- E-Mail Answers
Answer Posted / allapalli smarty
we maintain the temp. in plant and also to keep the excess
loss of steam at the end point by using which we increase
the efficiency of power plant
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
How to calculate ant test the burden of Current transformer
What is ramp signal?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
SUTIABLE FOR ohm's law super conductor
What is self exciting?
HOW WORK HEAT PLATE EXCHANGER
how to find the resistance and gap volatage of the diode??
why we cannot protect 100% winding of an alternator by using differential protection?
what is inverter and converter
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
Define open loop control system.
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
