Interested to Buy Any Domain ? << Click Here >> for more details...
in the thermal power plant, why we use the condenser (for
cooling the steam) when we have to heat the steam again.
i mean why we are cooling the steam,
- 6 Answers
- 10861 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The outlet temp of the turbine is brought down to transfer
more energy as it is proportional to the difference in
temperatures according to the laws of thermodynamics.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what r the safety measures in UPS ? explain all?
What is real time power factor control panel(RTPFC)?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
what will happen if synchronous machine rotor fed from single phase ac supply
what happened when we supply a dc current in dc motor?? can it worked properly?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
Electronic circuit
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
can anybody sent me power grid questions. what subject should i prefer for preparation?
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
what maximum range of star & delta in hp or kw ?
we need a ntpc previous papers
What do you mean by lighting transformer?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
