How we calculate the actual diameter of the TMT Steel
Answer Posted / kameshwar mahto (saroj)
Take 1m ling TMT Bar weight it.
weitht = d*d/162 (We have weight, find the diameter)
then calculate radius = radius = diameter/2
Is This Answer Correct ? | 58 Yes | 6 No |
Post New Answer View All Answers
As in practice, we are deducting every 2d for 90 degree bend but from where it comes means derivation or reference of IS Code.
What are your goals?
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
For removal of formwork of simply supported slab / beam from where to start the deshuttering? ( Max Bending moment of the simply supported beam is in the center hence is it required to start from the supports?)
Is there the dry coefficient of cement is constant?
What is bmc stands for in bmc software?
What is the likely strength of a 1:2:4 concrete mix?
What is dead load impact load live load
what is E
Dear Sir What is the Contraction joint for base Slab
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
Can any body help me out by telling hoe swelling pressure test of soil is carried out ? some body told me the procedure & formula (change in length /116.3*100%) but still i am confused ? pls help.
explain fie benefits of using standard terminology in the measurement process
At one time what is the height of Lift for concreting for Bridge Piers Class B Loading and refer the code.
What are the different methods for drawing an arc?