Answer Posted / pratik p

1.1 form factor is everywhere in world.....

K_f = \frac{RMS}{Average} = \frac{\frac{1}{\sqrt{2}}}
{\frac{2}{\pi}} = \frac{\pi}{2\sqrt{2}} \approx 1.110720735

What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.

2368

---

how we select ac fuse rating of an power inverter???

1825

---

What is dc current source?

1227

---

In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.

1527

---

i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test

1740

---

When is lag lead compensator is required?

1075

---

how to calculate

1631

---

What is the test block protection relay if any body know plz explained

1415

---

What are the basic component of a cro?

1184

---

What is the method of estamating of cable, CB,MCB ?

2106

---

how to work droop ct in generating station

2636

---

How can we calculate cable size in Low voltage & high voltage

1542

---

What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?

1861

---

3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?

1810

---

what is doid

2761

---