why substation are rated like 11KV or 33KV?
- 3 Answers
- 10321 Views
- TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / s
Because of form factor it is 1.11
| Is This Answer Correct ? | 38 Yes | 3 No |
Post New Answer View All Answers
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
WHAT IS LOAD CELL
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
What is the difference between the relay and the circuit breaker?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
internally connection of photvoltic module
Why CBCT rating is 50/1A
what are the factors to be considered while design the breaker either HT or LT??
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
Why the cores of large transformers build up of circular cross section?
