Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / uprabhagaran
PLC IS WORKING FOR PROGRAMMABLE BASED,AND ONLY DIGITAL
OUTPUTS,NO SCREENING.
BUT,DCS IS USING FOR CONTROL THE LOGICS,AND MONITORING.
| Is This Answer Correct ? | 4 Yes | 18 No |
Post New Answer View All Answers
What is first echo & echo window in radar type level transmitter?
what is the imbustion control loop
How can a d.p. Transmitter be calibrated?
What is ultrasonic flowmeter?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
what are the use of belew gear in general ??
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
In turbine, what does term CDP, NI, NH, HSSOC, means
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
principle of dead weight tester ?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
why is an oxygen sensor used in a boiler stack
