We have one router,we r using two routing protocol eigrp 90
net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?
- 6 Answers
- 8897 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / vivek kumar
Yes this is possible if we want all routing protocol run
with a time but it works according to Ad value.if eigrp &
ospf work with a time then its takes automatically eigrp
route according to AD value.
| Is This Answer Correct ? | 33 Yes | 6 No |
Post New Answer View All Answers
Hi Jitendera, Wat do u do..?? I mean r u working anywhere???? Basically where r u from??? If u don't hv any problem, u can say..?? Or else mail me mr.shahin07@gmail.com
What is a digital certificate?
Does a bridge divide a network into smaller sections?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
Can you explain encapsulating, carrier and passenger protocol?
Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?
In port based access-list which command you give instead of ip?
What cable called v.35?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
What is osi reference model?
What is default time of hello packets in ospf?
What is the difference between simple authentication and md5?
What is icmp protocol?
What command do we give if router IOS is stuck?
What is the difference between bus topology and hub?
