Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE THUMB RULE FOR DECIDING THE CURRENT RATING OF
COPPER WIRES SAY 2.5/4/6/10 MM SQUARE SIZES??
- 14 Answers
- 64931 Views
- Dubai Group, Saudi Delta Groups, Savitha Electricals, I also Faced
- E-Mail Answers
Answer Posted / arun kr. singh
The Thumb rule is:
Size of cable x 4 = Current rating of cable.
e.g rating of 2.5mmsq cable is: 2.5x4=10A
for 4mmsq cable is: 4x4=16A
6mmsq cable is: 6x4=24A
10mmsq cable is:10x4=40A
| Is This Answer Correct ? | 7 Yes | 23 No |
Post New Answer View All Answers
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
What aturn on methods of scr?
what is the difference between 4pole & 6pole DC Motors & give advantage ?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
What are the advantages of vscf wind electrical system?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
why servomotor motor? where i apply for best output?
What happens when ac supply is given as excitation voltage instead of dc supply
what r the safety measures in UPS ? explain all?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
