If a welder qualified for 2G,3G&4G positions,then is he
automatically qualified for 6G position?
- 2 Answers
- 4794 Views
- GMR, I also Faced
- E-Mail Answers
Answer Posted / gopi
If a welder qualified for 6g positiion,then he is automatically qualified for all position
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
explain how do seamless pipes looks like and when they r used?
How engine design needs to be changed to burn lean mixture ?
What are the some examples of a periscope?
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
Why required store to Factory?
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
how we can calculate the air consumption of any system.
Distinguish between the shear center and elastic center.
What do you mean by cotter joint?
diffuser increases pressure but in turbine pressure is decreasing when steam passing through casing?
how can u calculate efficiency of one welder in piping work.if we give support staff for his work.
When maximum discharge is obtained in nozzle ?
Explain the difference between projectile motion and a rocket motion?
general diesel engine we are using 15w 40 oil unfortunatley our oiller mis used the oil hudralic oil refilled when he doing the service which kind proplem coming in future?
What are the procedures on how to anneal?
