How do you protect your appliances from harm in case of
neutral failure in a three phase power supply set up.
Answer Posted / raj
Simply use ELCB or RCBO as incomer in the 3ph supply system
since if neutral opens it will trip the complete supply
without damaging to the system.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
Why power genaration in India is at 50HZ while America its 60HZ
State thevenin’s theorem?
please send me the L&T Emb. sys. placement papers and entire details of pattren
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
what is the voltages using in movie theaters??? why ??why not other??
What is the function of Governor in Hydro Power Station? What is the Function of Lightning Arrestor Voltage Transformer (LAVT)?
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
What is non-minimum phase transfer function?
What is the disadventage of gland earthing(power cable) if any. ?
What is the effect of pd controller on system performance?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
whit is 33kv power 300*300 cable full current with formula
what is differentila pilot supervision in the incomer control panel in the power station?