Answer Posted / prakash
Kva/1.732*kv for primary current
Kva/1.732*Lv for secondary current
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
the typical output of a solar cell is........
he compression ratio for a petrol engine generally lies between
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
what is the advantages og idmt relay over magnetic relay??
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
what is the terminal voltage of dc series generator running at rated speed at no load?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.
how we can calculate power factor in single phase & three phase ?thank u