Interested to Buy Any Domain ? << Click Here >> for more details...
What will hapen if we run generator below 47.6hz frequency?
- 9 Answers
- 19428 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / piyush maghnani
A sthe generator frq reduced the inductive load will draw
high current which will result in poor power regulation.
the motors will not be running with standard speeds. there
will be increase in harmonics disturbances. your generator
will be overloaded & loose synchronisation with grid supply.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the technical difference between On delay timer and a Star delta timer?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
What is the estimated total hydropower potential of india?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
along with technical test papers
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
Please explain me about Relay curves and their sources to read ?
How many devices can be connected in one zone of FACP
anyone knows service engineer in chennai for EDM SPARKING MACHINE.CHMER PULSE CD 60 M.pL GIVE ANY CONTACT NOS
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
What type of a DC motor would you use for a lift?
what are the main applications of transistor in non-linear region?
State ohm’s law?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
