Interested to Buy Any Domain ? << Click Here >> for more details...
how we can differentiate a motor and a generator just by a
glance?
- 5 Answers
- 10000 Views
- I also Faced
- E-Mail Answers
Answer Posted / t.swetha
In general motor is of the closed construction. And the
electrical supply is given to it whether ac or dc supply.
In labs for easy identification a brake drum is connected
to the shaft of the motor
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
How to calculate multiplication factor in kva example 500kva ans pls ?
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
what is PDU in transformer?? which company manufacture??
why we used dc supply for field in dg set
Why GRR starts from 60% of motor speed why not less than 60%?
Initially, when the input is not equal to the output — what type of response is this?
What is star-delta transformer?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
11000volt DG set carnt kaise banvay
