Interested to Buy Any Domain ? << Click Here >> for more details...
how to choose cable size with respect to load? how to
convert cable size in mm2 to sq.mm?
- 2 Answers
- 6109 Views
- MSL, I also Faced
- E-Mail Answers
Answer Posted / michael
depending upon the amps taken by the load, we should take
cable size. and the selection of cable size may vary for
copper and aluminum
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
what is the method of earthing of a transformer using electrodes?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
Testing procedure of DG alternator stability test
what is the terminal voltage of dc series generator running at rated speed at no load?
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
How to operate a ac chilar plant?
How to check the Bushings of the transformer?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is the height of DA, DAL, DB, DC & DDE tower?
what is active power & reactive power?
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
how to test and calculat the head and discharge in borewell compressor
State and define ohm’s law?
