in delta connection, why motor rotate in high speed
compared to star connection?
Answer Posted / lokeshraj
The voltage aplied to a moter terminal is the line to line
(LINE VOLTAGE). In star connection the phase voltage is
Vph/root(3) and in case of delta connection in is
Vph=V(line). And the voltage applied to the each winding is
the phase voltage that is greater in case of phase
connection so higher speed.
| Is This Answer Correct ? | 14 Yes | 8 No |
Post New Answer View All Answers
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
what is the difference between transformer,converter and transducer
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
Where can i get practical knowledge of solar system?
What does Bode plot tell you?
What is accuracy of a measurement?
i have interview in Pepsi company what type of question will ask please send the question and answeer
What is the instrument to check the rotating diode fuse of alternator in running conditions?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
what is the effect of back reactive power on the generator ?
circuit diagram of trip circuit supervision relay
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
what is harmonics? what are the factors it will depend upon
what is the IPC ? & what the uses ?