Interested to Buy Any Domain ? << Click Here >> for more details...
Why the Transformer Nuetral is grounded?
- 10 Answers
- 27815 Views
- Infosys, Khartoum Refinery, I also Faced
- E-Mail Answers
Answer Posted / amit
for earth fault
protection
| Is This Answer Correct ? | 8 Yes | 5 No |
Post New Answer View All Answers
what is the difference between earth leakage and earth fault?
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
why normally Generator rating are between 11Kv to 22Kv?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
What is purpose of reactor?.What is different between line and bus reactor?
How out of step protection relay works?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
what is the difference between electrical and electronic choke?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
orifice sizing how done, checking & selection
Explain different types of d.c motors? Give their applications
