if we want to increase the back up time of an UPS what
should we do ?
if we want to decrease the charging time of a
battery/batteries attached with the UPS what should we do ?
Answer Posted / nayan
if we attached another battery with ups then then the backup
time increased or if we attached a higher AH battery then
backup time increased. but if battery is higher AH that time
may be another charge controller assigned to reduce time of
charging and prevent the damage of UPS.
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
What is the maximum operating temperature for a thermoplastic insulated cable?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
what is mean by transition resistance of transformer?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
what happens to the supply voltage if there is any change in frequency?
difference between crane drive and line drive.
What are the types of excitation system?
Why is voltage is required to be within permissible range for an electrical equipment?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?