We have laid the single core Armoured cable 7 nos ( 2 each
phase & 1 neutral ) to cater our electrical load .
the issue is though we have Glanded the cable both the end
also givan the earthing to the panel both the end we are
facing a heavy sparking at the gland side. what could be
the reason.
Answer Posted / shantanau mishra
Dear Virendra
have you found any solution to your problem. Pl share.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
can indirect loading be called as phantom loading?
State and define ohm’s law?
Whar is the KvA rating of 33Kv substation & actual kv rating of power generaating station.
Why CBCT rating is 50/1A
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
What is step signal?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
how to find out 3 phase complex power in per unit in unbalanced system?