Can all intrinsic safe transmitters are provided with
inbuilt zener barriers? why
- 2 Answers
- 3802 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit patil
YES ALL INTYRENSIC SAFE TRANSMITTERS R BOUNDED WITH ZENSER
BARRIERS BECAUSE THESE R HAZARDOUS SIGNALS COMMING FROM THE
FIELD, SO TO AVOID ANY DANGEROUS EFFECT TOWARDS THE PANNEL
SIDE BARRIERS R USED THESE R SO THAT IF MORE CURRENT IS
COMMING FROM YHE FIELD THEN THE BARRIER BECOMES OPENE TO B
SAFE FOR PANEL SIDE.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
Give Detail information about plc,dcs,and scada system?
Can I calibrate the Electromagnetic Flow Meter on line and How.
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
What is the use of GMV in turbine?
