Interested to Buy Any Domain ? << Click Here >> for more details...
WHY THE WELDING JOB IS MAKE NEGATIVE IN MIG WELDING
- 2 Answers
- 7184 Views
- JSW, TATA, I also Faced
- E-Mail Answers
Answer Posted / vigneshwar
to cool the workpiece quickly.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
difference between microcontroller and microprocessor
What is ferrite?
What is booster in pneumatic ?
Explain the cycle of refrigeration system.
Where do railway steam engines carry there water?
Do you receive good benefits as an engineer job?
Draw a parallel circuit with one battery and two resistors. Derive the formula for resistance?
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
What is a torque converter?
What are the advantages and disadvantages of gear drives over belt drives?
The graphite in grey irons exists in the form of flakes which act as stress-raisers under tensile loading and consequently grey irons have relatively low tensile strength and ductility. Still grey iron is extensively used in engineering. Why ?
Which factors influence the type of fracture in failure of a material ?
what is varible
What will happen if boiler backfires?
What are the minerals needed to make or build a car?
