Answer Posted / anil kumar jaiswar
Circuit breaker is selected on the basis of,
1. Operating Voltage,
2. The Current carrying capacity,
3. The Breaking capacity,
4. The Making capacity of the breaker
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
How to back charge the Gas turbine generator
Why the cores of large transformers build up of circular cross section?
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
Tell me about ur past electrical maintanence job
all interview questions with answers of ntpc (2000-2009
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
what is mean by drives?
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
mccb service sittings be done?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
Define ohm’s law for a.c (alternating current)?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is class ab operation?