Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rsundareee
The transfor rating is in kva because as the iron losse
depending on the voltage and copper loss depending on the
current,so total loss depending on the voltage and current
so it,s called kva.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
Difference between HRG and NGR. Are they both the same thing
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
I completed iti in2004 I was worked in A grade contractor can I get c licence
distribution is maximum done by a)radial b)network c) parallel d)b & c
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
kindly send me 11KV MV motor differential protection procedure by primary injection method.
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
How to design pavement quality concrete by using C.R.C.P Method
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
