Interested to Buy Any Domain ? << Click Here >> for more details...
why transfromer rating gives in MVA Or KVA? Why not in MW
or KW?
- 6 Answers
- 22357 Views
- GIL, Siemens, I also Faced
- E-Mail Answers
Answer Posted / alpha cherian
Transformer Copper loss depends on the current drawn and
Iron loss depends on the Voltage. These are affected by the
load connected to it. While designing it is unpredictable.
Since power factor is not constant "KW" rating will be
wrong. Hence rating in kVA.
Kw rating = kVA rating x Power factor
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
Explain what is rated speed?
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
what is mean by D.O. in distribution line poles?
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
primery try cell?
What is the formula to calculate the rating of a three phase air circuit breaker
how we calculate the withstansing current capacity of wires&cables?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
Is vtg is controlled by the resistor? if else how much?
State magnitude criterion.
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
