How to model "IF ELSE" statement in matlab simulink?
Answer Posted / rachit kumar
An optimized solution will depend upon the test condition
of IF-ELSE loop. For example if the condition is relational
then you can use "Relational Operator" Block connected
with "Switch" block. Similarly the blocks can be changed
based on requirement.
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
What is the difference between acs 550 & acs 850
Why power factor should not be in leading (capacitive) mode of any load.
Formulae for calculating the transmission line losses for different voltage levels
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
should %impedance be high or low in a power transformer? if so why?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
How many types of probe used in cro?
How to Calculate the Fault Level of Electrical Installation
in science exhibition how lamp can blink when you clap near the lamp ? thank you