Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using DC supply for all protection relays, why
cant we use AC supply..???
- 1 Answers
- 5193 Views
- I also Faced
- E-Mail Answers
Answer Posted / n k singh
We can use AC also but additional shading ring must be
provided which gives sufficient phase displaced flux for
relay to be continuously on in negative half cycle of AC
supply also. In case of DC the flux is unipolar hence relay
will be on if DC is available.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
what is the meaning of the symbol << >> put in transformer drawing
what is the meaning of WYE and DELTA in Electric meter?
How does the slip regulator works as a startor
Mention the disadvantages of low power factor?
HOW TO CALCULATE THE VT SIZING?
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
What is referred to the electron in the outer orbit?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
how to meas-our losses for L.T & H.T
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
