in 1 cub/mt how much brick will come of 4" & 6"
Answer Posted / sunil khairnar
Its depends on Bond type,Morter thickness,Thickness of wall,
It will little difference between above conditions.
(6"-370nos & 4"-445nos)
Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
can we compare the combined core of DBM and BC density with average density of Lab DBM and Lab BC density
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 100 microns?
what are the proper pipes for salt water line
why we create short columns under grade slab?
What is specific gravity???
What is the difference between Grade I, II and III of GSB?
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
Will going from a 3-tap to 6-tap increase water pressure?
Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No. Loading Axial force Moment Shear 1 DL+LL 1950 600 20 2 Seismic load 250 4800 700
how many shuttering material required for 1000 sq.m built up area.
Why joints are provided?
what is the Purpose of Adding 20% of wet mortar & 1/3rd to Dry Mortar for PCC & Plastering & Rcc .is there any standard method for adding this .?
what is the water-cement ratio of mix design while 30mpa in 7 days?
what is called Bulk Density of aggregate?