Interested to Buy Any Domain ? << Click Here >> for more details...
if my 6 kva UPS gives 20 min. backup at 100 % load, then at
25% load what is the backup time?
- 17 Answers
- 19321 Views
- I also Faced
- E-Mail Answers
Answer Posted / miracle
100% load means = 20 minutes so 25%x20minit=80 minits
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
how to calculate the total flow in square root
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
why Fahrenheit unit of moistur analyzer transmitter
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Please asked me How calculate DCS controller memory.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
