Answer Posted / raju4472
yes, i agree both the answers and if CT is saturated after
high voltage on secondary, then there will be short circuit.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
Difference between RCCB, RCBO and ELMCB.
Is there any standard guidelines/Criteria to design NGR/NGT.?
what is auto re-closer?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
previous year paper of ntpc bhel for degree in electrical enng
What kind of maintenance is conducted for Transformer
What is order of the system?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Rules and standards of electrical control wiring ?
